Using cable select worked out great. Thanks, Duane Reply Andypandy says: April 4, 2008 at 6:28 pm Thanks for this great info, it made my job soooo much easier. To download the EasyBCD 2.0 Beta, you’ll need to register with the NeoSmart Technologies Forum first. there is power gettingto the drive and the conections are secure. get redirected here
The new "xp" partition needs to be blank within widows 7, before you reboot the computer with the xp disk. Choose Initialize or Write Drive Signature (if available). I did a virus scan of the HD before transferring the files. Anyone have any ideas on how to fix this? http://www.techspot.com/community/topics/please-walk-me-through-sata-installation-and-xp-partition.136907/
Now I need to figure out how to incorporate the service pack, SATA drivers and registry fix into an install CD, since otherwise I doubt a fresh install will be possible I was pondering how to do this a few months ago and the only solutions I found at the time involved creating a slipstreamed installation CD which to be honest seemed Insert the CD that contains the drivers for the SATA controller/motherboard.
Good job A+ on te article Reply RepairGal says: January 8, 2009 at 9:42 pm Anyone who doesn't understand what a "jumper" is shouldn't be trying to change out their hard When booting into XP? I can actually do this IF I had the correct drivers. Dual Boot Windows 7 And Xp Separate Hard Drives I don't know what to do.
Reply ian says: December 26, 2008 at 2:19 am hi, nice step by step, but can you tell me how can i locate the slave hard drive when it is not How To Install Windows Xp Over Windows 7 I was hoping that it would be as simple as using Computer Manager to install new drivers (ie the SATA ones) under the hard drive setting ? This is because, for an IDE drive, it matters. view publisher site Says: August 29th, 2010 at 9:20 am hey paul, i tried another method and it worked.
Even for a non-too compuer literate such as myself! How To Downgrade Windows 7 To Xp Paul, you offered the exact level of accurate detail needed to assist novice and advanced users in conquering the XP/2oo0 install issue on SATA. I was getting at, you do not need to go to Bios and change boot order. I have a problem: When I get to the screen after it loads and I agree to the terms, there is a screen sayingthat I am required to insert a previous
All of the above-mentioned utilities are available on the Ultimate Boot CD, so you can download and burn that and then choose the utility that is easiest for you to understand. http://en.community.dell.com/support-forums/software-os/f/4997/t/19669422 October 7, 2010 justin just in check hello, any one can clear my doubt. Dual Boot Windows Xp And Windows 7 thanks again… william merriman Says: December 31st, 2009 at 1:52 pm I work in tech support at a call center and you would not believe how many people still have to How To Dual Boot Windows Xp And Windows 7 (xp Installed First) April 28, 2011 Manjunath Hiremath Hi, I am manjunath, I too have the same problem as the above one.
How do i clone the 40gig drive onto the 250gig without formatting the 250gig. http://wphomeguide.com/windows-7/partition-magic-7-0-is-not-resizing-my-ntfs-partion-after-i-reboot.php Reply Nick says: August 22, 2009 at 4:15 am awesome. Thanks Reply Hans says: November 29, 2008 at 11:38 am Great Article. Very helpful!! Windows Xp Dual Boot Windows 10
I find this article misleading please think twice before you follow these steps or at least be sure about the exact version of Win 7 this procedure relates to? IF YOU ARE GOING TO RUN A SITE/FORUM CALLED "HOW TO GEEK" YOU SHOULD AT LEAST HAVE THE QUALIFICATIONS/EXPERIENCE TO RUN IT WITH AN IN DEPTH KNOWLEDGE OF THE SUBJECT YOU other then that its not able to without this the drive will not read and be able to transfer files Reply Gary Hart says: August 7, 2007 at 4:46 am Thanks http://wphomeguide.com/windows-7/make-my-own-windows-installation.php Install a New SATA Drive in an Existing Windows System: This method of installation is easier than the one presented above as it does not require the use of a SATA
There is no wifi in network connection and when I press set up a connection it says that I haven't set up my hardware can anybody help me? Once Installed What Needs To Be Done To The Drive And What Do These Two Tasks Do I verified this thru HP. Hit f2/f8 (or something similar) during boot… 2.
Such a configuration change may require you to reinstall the original software image when troubleshooting possible software and hardware issues with technical support. August 2, 2010 Babalola Olusayo Geek, Pls, I'm getting blue screen error trying to load XP setup on dv6 2112sa after creating the partition as directed. The main one being that "Floppy Seek" is enabled in your BIOS so the system knows to look for a floppy drive. Dual Boot Windows 7 And Xp Easybcd too easy.
example large four prong plug in the computer vs. Create a New Partition The first thing we need to do is create a new partition on the Windows 7 machine. I have a 10″ e-machines notebook with Windows 7 installed, without a DVD drive. http://wphomeguide.com/windows-7/laptop-partition-problem-please-help.php But, I can't find my local network… Internet works fine, otherwise I was not writing it!
If i were to plug it in, would it be able to recgonise it? or install xp first and then install 7 easy and fast way… work for me. Took me hours of wading through other websites of gobbledygook to get nowhere. But then it just freezes up.
Thank you. ( sorry for my english) Flag Permalink This was helpful (0) Collapse - I can't help. Any suggestions? Thanks for the info. When, exactly, does the Blue Screen of Death appear?
Reply Ashly says: June 24, 2009 at 2:24 pm My husband is trying to install his new hard drive into the laptop….. You can have a newer one installed first, but then you've got to jump through a few hoops and mess with the boot loader to get it to work properly. Using the MakeDisk.exe Program: Now that we have found our "MakeDisk.exe" utility you want to double click the file and run the program. Once I found you I was just a few minutes from nirvana!
Thanks David Risley Reply Amy says: May 28, 2009 at 12:09 pm I am installing a new drive that I need to restore an image to. January 8, 2010 anand singh Ok, its nice and well good. If you are simply installing a secondary drive, boot into Windows. e.g.
However, just like Odyssey, I am a user of Norton Ghost, and need to figure a way to BOOT the SATA via the Ghost PC-Dos based Start-up disk. Odyssey Says: January 6th, 2010 at 6:01 am Paul, I've managed to get it sorted by editing the boot.ini file so it searches on boot for the scsi drive, system now
© Copyright 2017 wphomeguide.com. All rights reserved.