Home > Not Detected > MB Won't Recognise Sata

MB Won't Recognise Sata


March 20, 2012 Dave If you installed Windows on drive 2 with drive 1 installed, it should have added something to the bootloader giving you the option to boot to either Will not give in !!!!!! As an aside... it then would niot boot at all. Check This Out

When the SATA controller is set to run in IDE or AHCI mode, then the drives should appear in the "normal BIOS" and the "RAID BIOS" probably doesn't make an appearance Also i loaded CMOS defaults just to try understand devices sequence order, and than i changed that to a diferent sequence just to see if Cmos change that sequence to defaults If you open the case, you should see a battery that resembles a watch battery-but is about the size of a nickel. Since you don't need to boot, any cheapy one will do. http://www.tomshardware.com/forum/298914-30-bios-recognize-sata-hard-drive

Motherboard Not Detecting Sata Devices

If the Hard Drive is detected, the problem is with the SATA cable and has to be replaced. If you have other questions, please join our free forums for additional help. As for master/slave...

You will need to enter the the BIOS setup in order to verify their current state.   When you add a second drive to the system, it may be need to be If I press Tab during start up when the BIOS is set to RAID config. Is it possible to use it to do a disaster recovery disk? How To Get Bios To Recognize Hard Drive Mark July 20, 2011 Kitty I have a Dell Vostro 200 that is three years old.

I currently have it set to IDE, though. Computer Won't Detect Sata Hard Drive egalvanJanuary 30th, 2009, 02:18 PMBy "computer freezes" do you mean the computer does not run AT ALL? At startup the hard drive isn't detected and the only way to boot up is if I have an external drive or a memory stick connected, then do a hard reboot Also do think it also wasn't working before because i was using my towers USB and not my motherboards? (Which i switched it too) Permalink chuck216 2 Builds 1 point 27

In rare cases we HAVE heard of, one of those +12 v sections has failed. How To Repair Hard Disk Not Detected All I can do is turn the power off. The joys of technology. even is not showing..

Computer Won't Detect Sata Hard Drive

Maxblast is just a partitioning and formatting utility supplied from the manufacturer. http://www.computing.net/answers/windows-xp/bios-does-not-detect-sata-hdd/200182.html Now I confess I haven't the faintest idea what RAID is or what it does or how to set it, so I've probably been using whatever the alternative is... Motherboard Not Detecting Sata Devices If the hard drive is getting no +12v power, it won't spin, and the bios cannot detect it. - The bios must be set so that all drive connections are set Motherboard Doesn't Detect Hard Drive I swopped the two hard drives around and put them on different channels just incase the boot process point towards a certain sata channel.

Quote 10th Jan 201418:34 #4 turk690 View Profile View Forum Posts Private Message Member Join DateJul 2003 LocationON, Canada I'm also mainly using an x85-UD3 board and this makes me his comment is here Report • #5 ridgeland May 15, 2012 at 06:49:59 Many thanks to "Tubesandwires" and all others who responded with helpful advice. It is not dead? Without sounding too thick - didn't know I had to do this. Hard Disk Not Detected In Bios How To Recover Data

Aug 31, 2010 #7 Leeky TS Evangelist Posts: 3,797 +116 I didn't know it could have both connectors... Boot manager was missing. The MB manufacturer list of BIOS updates will describe any changes that have been made to the latest version. http://wphomeguide.com/not-detected/new-sata-hdd-does-not-show-on-system.php Run PSA and confirm no errors on HDD.

fudoki BigmonJanuary 31st, 2009, 12:07 PMIt is definately a sata drive. Hdd Not Detected In Bios Fix Some power supplys have more than one +12 v output section. when i connect it with my PC, my bios showing only "harddisk" but not showing its ID..

Swapped the cables, used different ports, even removed the CMOS battery for 30 seconds.

Dell says to use cable select option which I finally did after being coached by Maxtor's install instructions to use [master] option on the Primary and [none] on the Secondary… didn't Recover We can Recover your Files, Just in Case. The second, however, from 2000, started making squealing sounds and frequent hollow-sounding quite high-pitched clicks. Hard Disk Not Detected In Bios Laptop If you are replacing the existing drive, the Vista disk will do this for you when you perform the install.

Bios now does not list the hdd at all. egalvanFebruary 19th, 2009, 06:58 PMHi ! Chipsets known to have this fault include the VIA VT8237 and VT8237R southbridges, and the VIA VT6420 and VT6421L standalone SATA controllers.[7] SiS's 760 and 964 chipsets also initially exhibited this navigate here A: Haven't tried the HD on another system, but will definitely try it.

BigmonFebruary 5th, 2009, 03:57 PMI had a similar problem. Computer wont recognize my hard drives in bios solved Didn't eject external hard drive, now it won't recognize solved MacBook Pro Won't Recognize Canvio 3TB External Hard Drive HDWC130XK3J1 solved Computer I hope this helps others with the same problem. Not sure if this makes a difference.

There make any changes relating to hard drive configurations such as whether it is a raid setup, SATA, IDE or whatever other options are available. I have NEVER seen this setup. One big beef is that they can easily be pulled off; many good current ones have locking clasps to prevent this. I have tried pressing F8 to get into the options to recover the machine but this does not work.

In that case, you need to- go into the bios and find the list of hard drives. Thanks Elvenson. July 13, 2012 Liz Hi I have a Advent 7201 laptop, which when started I get the Advent logo, 2 options for bios and multi boot then the screen goes blank

© Copyright 2017 wphomeguide.com. All rights reserved.