Home > Motherboard Problems > New Mobo - No Power

New Mobo - No Power

Contents

I have power to the board because the led light on the board lights up. Examine the video card, and make sure that it’s evenly seated across the width of the PCI-Express slot. I put my old motherboard back in last night and it's doing the same thing to. No fan is spinning if the PSU cable is connected to the MB, no matter what I do to the motherboard power sw pins. http://wphomeguide.com/motherboard-problems/no-power-even-with-new-mobo.php

My $.02, BT BTW, some hardware info would help us diagnose the issue better. Can you boot and get into the BIOS/CMOS? Thanks for all the help and input. We use data about you for a number of purposes explained in the links below. http://www.digitaltrends.com/computing/five-reasons-why-your-new-motherboard-doesnt-work-how-to-fix-them/

Motherboard No Power

I've tried: Taking out the RAM A CMOS reset Swapping out the video card Verified that the mobo is getting the correct power (the blue LED shows that). In all the years I've looked at and built computers the only two times I've had a CPU fail are one when the heat sink wasn't properly fitted, and 2) when Putting a real "load" on the outlet, like a lamp, is a better option.  Verify that the power supply voltage switch is set correctly if you're on a desktop. TechSpot Account Sign up for free, it takes 30 seconds.

The upper limit of the FSB freq is around 350 MHz. Yes, it's perfectly fine to run your portable computer without the battery installed.If your computer turns on after trying this, it means that your battery is the cause of the problem A way that might be easier for you is to use the main power plug. Motherboard Problems Symptoms Many people forget the second connector.

Posts: 2,191 +592 So no power period...Did you check that the power button is hooked onto the correct spot. You either have a dead mobo or it's shorting out on the case. Plasma Flat Panel Displays Plasma Flat Panel Great Found Deals! http://www.techspot.com/community/topics/no-power-after-motherboard-install.199528/ If so, double check the mounting standoffs in the case, and see if an extra one was accidentally installed - that extra standoff would be shorting against the bottom of the

You would not be able to seat the cpu in the socket if it was incorrectly positioned. Motherboard Problems No Display Important: If it appears that your computer is in fact receiving power (lights on the computer turn on, fans are running, etc.), even if just for a moment, see my How It's possible that you can pass the POST with a defective video card. That ram compatibility can be finicky I guess.

Motherboard Won't Power On

New system- Motherboard- z87-d3hp CPU- i7-4770 Gpu- GeForce GTX 460 Ram- Kingston DDR 3 Psu- Shaw p4s6 860w. http://www.sevenforums.com/hardware-devices/245910-new-motherboard-no-power-up.html If the case and PSU are new, there's little chance they are bad. Motherboard No Power Using an inexpensive unit to test might help? Common Motherboard Problems If not then I'd bet the mobo is bad.

I just screw the MB in place. http://wphomeguide.com/motherboard-problems/power-up-issue-with-new-mobo.php Digital Hi-End Projectors - $3,000+ USD MSRP Rear Projection Units OLED Technology and Flat Panels General OLED Technology Great Found Deals! Pressing the power button - nothing 2. The orange modem light comes on but nothing else turns on. Motherboard Won't Boot

Installed it all and then no power when I try to switch it on. Blu-ray Software Blu-ray Disc Great Found Deals! CPU needs this signal to boot.You can turn on the PSU by completely disconnecting the PSU and using a paperclip or jumper wire to short the green wire to one of check my blog Some older power supplies may not have this extra plug.

Eternal.Premium Memberjoin:2001-10-03Bellevue, NE·ooma ProtusMose Premium Member 2004-Aug-23 8:54 am Installed new motherboard. How To Fix A Motherboard That Won't Boot The CPU fan or HDD's never turn over which is where my confusion starts. If you can't find your manual, your motherboard's manufacturer should have a PDF version of it on the company's site.

Here's How to Do It Article Try This Simple Lamp Test to Verify Power Supplies List Replacing PC Hardware?

Generally rebuild it, could be something as simple as re-seating the components. Please try again. Dec 31, 2009 #2 micropage7 TS Rookie If the board light on, it means the power runs, try to remove all tha attached to ur board, maybe you should check the Motherboard Problems And Solutions TechSpot is a registered trademark.

also try using known working components when re-building, cables, power connectors etc...if your anything like me you will have components lying about. I have not notice any beeper at all on the board.http://www.newegg.com/Product/Produc...82E16813130231http://www.msi.com/index.php?func=do...93&type=manual Oddly, I have had some MBs beep even when there is no beeper visible, At any rate, you can still It's also possible that you have a bad mobo as well.One last thing to try, pull the mobo out of the case, power supply as well (four screws to remove) and news Login now.

© Copyright 2017 wphomeguide.com. All rights reserved.