Home > Hard Drive > Maxtor Is Either Detected In Bios Or During IDE Scan

Maxtor Is Either Detected In Bios Or During IDE Scan

Contents

I installed a 1TB SATA drive and it showed up fine in the BIOS but XP acted like it didn't exist. PaperdocFeb 25, 2010, 8:18 PM Well then, your D: drive may have developed a significant hardware fault. Using the old drive to boot and connecting the new one as a slave, I see all of the files created by the restore disk. If one is found, it stops there and executes those files. Check This Out

AnonymousJan 18, 2010, 9:40 PM Paperdoc said: The problem may be you're not looking in just the right spot . Worst case scenario is having to telephone activate the install, at which point you'd verify its installed to one PC anyway. Related Resources 2nd SATA drive detected in BIOS but NOT in Windows Disk Management 2nd SATA drive detected in BIOS but NOT in Windows Disk Management solved Bios & Device Manager maybe it is acting only as a RAID (SCSI) controller when enabled and the bios options are not reflecting this limitation.

Hard Drive Shows Up In Bios But Not Disk Management

As it is full of data and pictures I do not want to reformat it. I can pull it out by just removing 1 screw. http://www.pctechbytes.net/ April 1, 2012 beckhamj I can not see it under my computer. Personally I prefer the version that has you burn your own CD-R and then boot and run from that, completely independent of an OS on your hard drive.

That could be a complete drive failure, or a failure of its own printed circuit board system, a bad connector cable, or even a bad connector itself. Dyan Reply Dyan says: December 29, 2007 at 11:32 am Joshcore, can you reply me. If this information has been damaged, then you may be able to find someone who can rewrite that information to the drive. Hard Drive Detected In Bios But Not During Windows 7 Installation My new 1.5 TB drives were recognized by my bios and raid setup bios but they were not in XP disk management.

I rebooted in Setup and BIOS showed the Second Hard Drive to be a Maxtor with 37.19 GB! Windows 10 Not Detecting Second Hard Drive Congratulations, your new drive is installed!  Now that you have installing your hard drive under your belt, you might be interested in partitioning your hard drive (that means dividing your space so Reply nick says: October 19, 2009 at 11:30 pm Hey my pc wont reconize my hard drive,even a exernal hard drive. https://www.pctechbytes.com/hardware/hard-drive-does-not-show-up-in-bios/ Be careful with it too!

It's just the way it's done. Hard Drive Shows Up In Bios But Not Disk Management Windows 10 December 31, 2013 Top Rated Recent Popular Recent Find us on Facebook Contact Us Privacy Policy Terms of Use Sitemap Featured Posts Copyright © 2017 PCTechBytes Articles & News Forum AnonymousSep 7, 2009, 3:31 PM I am user, not an expert, but i decided to install my own second drive (Hitachi 500 gb) in my Dell Dimension 9200 running Vista Home The Via/Gigabyte notes state i should be selecting VIA ATA/ATAPI Controller but apparently its not in the list.

Windows 10 Not Detecting Second Hard Drive

October 30, 2009 anca Hi there, I have a dell inspiron 1525 who already burnt once the HDD and now it did it again. http://www.tomshardware.com/forum/156450-30-8gpnxp-issues-drives If that is the case, search the web for way to fix that. Hard Drive Shows Up In Bios But Not Disk Management You should have SATA drivers for your motherboard -- do you?? Install/diagnostic/repair Software From Seagate Im figuring it was old information and they just merged it into the first item.

Sorry I don't remember the exact message.I then tried to set "SATA RAID/AHCI Mode" to AHCI, it is said that it is to support hotplug but I don't know what else http://wphomeguide.com/hard-drive/maxtor-hd-problems.php by TriMagna / March 9, 2006 10:11 PM PST In reply to: SO Wrong On SO Many Levels I have several Dells. Once in there, check that the bios is detecting your Hard drive and make sure it is on the Boot Sequence. We'll use Disk Management to examine. Second Hard Drive Not Showing Up In Disk Management

I've only talked already about 3 of them. We will see with the upcoming preview.>> This configuration would be OK for me but I still wonder whether thesystem> should be able to boot from a CD when SATA RAID/AHCI I installed Hard Disk Sentinel and the disk is shown but no action on the disk. this contact form Would you please kindly walk me thru?.

I have a dell and it was givng me a message that there was no boot drive installed, repeatedly for months. Hard Drive Shows Up In Bios But Not Windows 8 Twenty years experience tells me the drive is readable but needs to be low leveled or (safer) replaced BUT I'd like the date on it if I can get it. Get the answer AnonymousFeb 22, 2005, 8:50 PM Archived from groups: alt.comp.periphs.mainboard.gigabyte (More info?)The controler is indeed configured to work as an ATAPI controler not a RAID controler.

My computer worked fine i have had it for less than 2 years.

All clean of course. If you are using eSATA, is it an eSATA port the was built into your mobo, or are you using an adapter plate on the back that plugs into one of When you install Win7, change the boot order to 'CD/DVD' first. (After it all works, you can swap it back to 'ON BOARD IDE/SATA' first, but it's not vital.) Last thought, Hard Drive Detected In Bios But Not Booting January 19, 2010 mIKE hey I have a really stupid problem I have a drive that doesnt show up in an alienware laptop.

Full Format takes many hours!When you are done, reboot and your newly prepared hard drive should show up in My Computer as an empty unit ready for use. my email address is: [emailprotected] thanks Reply dg says: March 10, 2008 at 3:49 pm hi, i hav just purchased a seagate 250GB sata drive. Cant do nothing else. navigate here August 3, 2011 satendra sharma hard disk not detected in bios setup.and change the sata port but same reason.

Not sure if the drive is dead or alive.... I always recommend updating an older computer if it is within your budget. what do i need to do in order to make it work in different motherboard? Now you got me concerned about it not accessing the drive at high speed without the driver....Hmmm.

What size Partitions / Volumes do you want? Hope to get an answer here. I have two IDE Hard Drives connected to a J-Micron Raid Controller which was running them perfectly fine off of my Windows XP build two days ago. If you build up your new PC with all the components (Drives, graphics cards etc) then install Windows 7, it will work fine.

There are many NetBIOS versions on the net you can download, you just have to look in the right direction.7) If you don't have a virus scanner I would recommend installing SATA HD not detected using VIA ASUS motherboard Started by shaokahn , May 10 2014 04:12 PM Page 1 of 3 1 2 3 Next Please log in to reply 30 Using cable select worked out great. Anysuggestions?

retail, OEM, manufacturer supplied) Sep 15, 2010 #6 whakoworld TS Rookie Topic Starter @Leekie: Its retail windows 7 Ultimate. Your computer should see and read your drivejust fine. I'm unable to use the BIOS any further and must reset. A+ on the info!

After that I could notice that the system is very slow in booting up. I plugged my 2 Maxtors on IDE2 and the PX-2410 and the PX-712A on > IDE3.>> The 2 Maxtors are detected and the PX-2410 is also detected but not the > So I tool the hard drive and connected it to the external case and linked it with my other desktop, retrieved the files from this drive and formatted the drive. While the PC was on I touched the 160GB Seagate SATA drive and yup its running and warm so power is going to it.

© Copyright 2017 wphomeguide.com. All rights reserved.