See the directions for a repair install, sixth post from the top, in this forum. The 4 pin power cable is polarised, so it will only connect one way; sadly, the data cable - the ribbon cable - is sometimes polarised, and sometimes not. SHOW ME NOW CNET © CBS Interactive Inc. / All Rights Reserved. They both use the gray ide cable (2" wide). Check This Out
Shut the machine off, pull the power plug out of the back of the old computer, and remove the computer access panel or cover. If not it could try to boot the old HD first (depending on your SATA order). All Rights Reserved. All Rights Reserved Tom's Hardware Guide ™ Ad choices Articles & News Forum Graphics & Displays CPU Components Motherboards Games Storage Overclocking Tutorials All categories Chart For IT Pros Get http://www.techspot.com/community/topics/master-to-slave-virus-transfer.28829/
The time now is 06:03 AM.
Related Resources [Solved] Hooking up old computer\'s internal hard drive to new computer as slav Hooking my old hard drive up to my new computer solved can i hook up an I intend to use windows easy transfer to copy everything from the master HD to the slave, then make the slave the new master. Therefore, I can't get to safe mode to scan or do any sort of troubleshooting.2. How To Get Data Off An Old Hard Drive Join the community here.
Why don't we use weights to store energy? How To Connect Old Hard Drive To New Computer I can see the new drive (it's "E") in "My Computer", so I'm assuming that everything worked fine. The PC requests the information and then waits until it is processed by the drive... https://www.cnet.com/forums/discussions/9-16-05-moving-your-old-hard-drive-to-a-new-computer-125650/ I didn't put quite enough thought into my answer, obviously...I was assuming (Perhaps incorrectly) that the drives were both PATA and of the same generation...
You can obtain inexpensive backup software that will automate this task. Add Old Hard Drive To New Computer That box is your hard disk drive, where all your data lives. Newest version is wonderful! If I go through the steps above and reformat the hdd then how will I be able to do a fresh install of the OS if I do not have any
Flag Permalink Reply This was helpful (0) Collapse - This thread is 11 years old by itsdigger / February 17, 2016 1:28 PM PST In reply to: Hello Why bury your It would be very confusing, to say the least, and probably not at all successful. Connect Old Hard Drive To New Computer Via Usb Then too you can always run a Win 2000 repair on the old one or upgrade it to Win XP. Sabrent Usb 3.0 Sata/ide 2.5"/3.5"/5.25" Hard Drive Converter Usb-dsc9 By applying key insights from the areas of molecular (phylo)genetics, microbiology, virology, ecology, systematics, immunology, epidemiology and computational science, they demonstrate how reticulate evolution impacts successful survival, fitness and speciation.Reticulate evolution
All Rights Reserved Tom's Hardware Guide ™ Ad choices current community blog chat Database Administrators Database Administrators Meta your communities Sign up or log in to customize your list. http://wphomeguide.com/hard-drive/problem-with-slave-hdd.php Connect a 4 pin drive cable. That's how you're going to be jumpering the drive.On the back of the drive, where the cable plugs in, you'll see a tiny array of 7 or 8 gold pins, with F8 for safe mode and F10 for console, do not work. Install Old Hard Drive In New Computer
VIPChristianMar 4, 2015, 8:00 AM Yes but for some reason my windows 8 , now 8.1 isnt seeing it,Vantec SATA/IDE to USB 2.0 Adapter Ask a new question Read More Hard What a great teacher. Thanks again for your help (or anyone else who wants to reply). this contact form They do indeed have different controllers and will not interfere with each other.
Her main research interests lie in evolutionary epistemology and non-Darwinian evolutionary theories, how the latter differ from the Modern Synthesis and how they can be implemented into the linguistic sciences and Usb Hard-disk Drive Enclosure Just make sure to write down the position of any switch or anything else before you do any changeIf you have only 1 IDE connector in your mother board:Make sure the I assume you want to do this to keep access to your data rather than to run programmes from it.
A quick note about hard drives. You can also run any off-line virus scans using a rescue disk on such a system. I think the internal hard drive is always connected to "SATA 0" and it always boots that one as the primary boot drive, and since I just added the old hard Moving Hard Drive To New Computer Windows 10 Both rotational and access time.A drive designed to run at 7200 RPM cannot run at 5400 RPM at all, without replacing the PCB with one that has a 5400 RPM controller.
It's been my experience, when moving my hard drives (2, dual boot) from a fairly new custom built computer to a new custom built computer (Windows XP), that I had to Proffitt Forum moderator / February 17, 2016 1:30 PM PST In reply to: Hello Folk may not notice and it's difficult to answer here. The old HD was only 50gig so I'm assuming is was a lower end HD even for 2004. navigate here It works fine.Thanks,Sean Flag Permalink Reply This was helpful (0) Back to Computer Help forum 123 total posts (Page 1 of 5) 01 02 03 04 05 Next Popular Forums icon
Congratulations! I have just recently had a slave/master setup and wondered about virus movement from one to the other (master would be the only one to have internet acess)??? Why was Seattle chosen for the site of Expo 62? Two different controllers so their is no latency when running off the slower drive.
If your new computer is still using the older PATA technology - surprising, but possible - then just connect your old hard drive as a slave device on the primary controller.Master, Anyway, I was able to boot to safe mode and run Malwarebytes and Windows Security Essentials, to remove the virus. However, all of this only applies if your old hard drive is a PATA drive, and your new computer has a SATA drive. Cable Select allows the physical position of the drive on the cable to determine if it will be seen by the computer as a master or a slave drive.
Frequently, people upgrade their new machines because the old one stopped working properly; however, the reason it stopped working properly was often due to an unsuspected virus infection. Of course you would set the faster drive (newer) as master and the older drive as slave. Yes, you can easily get a virus just from plugging in an infected hard drive. It's a nice thing that they put an extra one in there, I guess it's specifically for purposes such as these.
I only changed to second plug to 3-7 to make it the slave. Both computers are Dell, the old one I bought in 2007 and is Vista, the new one is Windows 7. Hi,I am contemplating having to follow these instructions as my old HP Pavilion's power supply died today, and I cannot retrieve files. Alternately, you could simply reformat your old drive; but this will erase every scrap and smidgen of your old data.So there you are - a quick guide to moving your old
I would like to removethe hard drive from the old system and install it into my newcomputer. That may be the toughest thing to find if you didn't migrate your system up from earlier OS's. With that said, installing the old drive in the new machine is quick and simple; but there are a few gotchas to keep in mind. No problems installing or formatting.
From the standpoint of the internal activity of the drive yes, but for all relative purposes to operation, no.
© Copyright 2017 wphomeguide.com. All rights reserved.