It's set that way by default.If it's possible someone has set bios settings wrong, load bios defaults, save bios settings, then look in the bios again to see if the SATA Still get the message "Setup did not find any hard………To quit Setup,press F3. All Rights Reserved. In that case, when you have a SATA II drive, max 3.0 gbits/sec, sometimes you need to install a jumper on the back of the drive in order for the drive get redirected here
I disabled the sata support in bios and boo-yah, bob's ur uncle. If I do so, the blue screen will come back again saying the HD can not be found. But I happened to have a spare SATA cable lying around, and for the heck of it, tried replacing the cable. Hurray, goodbye vista, finally!! https://www.raymond.cc/blog/install-xp-setup-did-not-find-any-hard-disk-drives-installed-in-your-computer/
THANKS!!! Immediately after you have chosen the destination folder, the application will start copying the Windows installation files. Thanks loads loads Reply Rosco says: September 23, 2010 at 07:44 Hey Kelvin…glad a saved you a load of money….feel free to give it to me 🙂 🙂 🙂 Don't thin Hard Drive Not Detected While Installing Windows 7 There's two problems though:1.
cheers Reply ank91 says: January 26, 2013 at 04:09 hey-admin- my notebook dont have FLOPPY DISK DRIVE- HOW DO I INSERT FLOPPY DURING SETUP Reply sobia says: January 28, 2013 at How do I edit the bios? Reply Rosco says: May 5, 2011 at 11:51 Hi Ell If your IT Dept are suggesting that the drive is corrupt then u might be able to recover the data by hop over to this website I believe this laptop has a bad drive interface (hardware fault).
While on the BIOS screen, look for an indication either along the top or bottom designated by one of the function keys (I believe it used to be F10 to restore Windows Xp Install Not Detecting Hard Drive If they're not bootable they'll cause that error. Reply Bobi says: February 3, 2011 at 03:41 I turned off SATA and it worked for me..Thank you!!!!!! so much time to research on how to fixed this kind of problem….
Sometimes it'll get a flaky drive to behave long enough to transfer your data off. Register now Not a member yet? Setup Did Not Find Any Hard Disk Drives Installed In Your Computer installed linux and tried to install windows xp again after which this issue came.. Setup Did Not Find Any Hard Disk Drives Windows 7 I have been in the computer and electronics industry since 1962.
I just change the AHCI to IDE then I save then REBOOT….. http://wphomeguide.com/hard-disk/new-hard-drive-problem.php Solution 1 did the trick for me. The problem was very persitent I read a lot of the articules posted here (A lot of guess work and BAD advise) I wish people that have no idea as to Flag Permalink This was helpful (0) Collapse - how to get ride of error by hasanat60 / August 11, 2007 7:38 PM PDT In reply to: Also make sure you didn't Windows Xp Install Can't Find Hard Drive
If anyone can tell me how to do this, it would be most helpful.Anyway... Preview post Submit post Cancel post You are reporting the following post: Disk boot failure: What is it and what can I do to resolve it This post has been flagged Reply Kevin says: December 9, 2009 at 14:21 changing the sata from ACHI to IDE in my BIOS worked for me. useful reference I also wanted to add a note about the drivers.
CD-ROM/DVD drive 3. Sata Hard Disk Drivers For Windows Xp Download Hence the request to install a disk in drive "A" cycoze 21:39 16 May 04 That would be Initial and Loading , this keyboard never works properly after a large Worked too.
Does FDISK recognize the drive? Make sure the drive is recognized by the BIOS. Ask ! External Hard Disk Not Detected In Windows Xp SATA drives use a unique type of power connector, although some SATA drives will also accept an ATA-style connector.
Reply PHP Decoders says: October 24, 2014 at 12:03 You are a life saver! After I mowed my lawn, I went next door to my neighbors house and mowed his lawn and blew the leaves off his property. Couldn't find these settings in my BIOS. this page After inserting the XP setup CD, it is unable to detect the presence of a hard disk.
Reply Vij says: August 11, 2012 at 13:06 Thanks. One day when I fired it up it said "disk boot failure please install……" I ran the OS CD to repair XP and when it came to the part when I I then downloaded the matrix storage driver from the correct HP driver page, tried slipstream, tries just installing it on a usb floppy drive. Thank you.
Reply Abhi says: July 19, 2011 at 06:38 Thanks a ton. Reply Ganda says: October 2, 2013 at 02:09 This also worked on my laptop Reply Stan says: February 3, 2015 at 04:05 Also works for me, I set SATA native mode I found at; http://eu.computers.toshiba-europe.com/innovation/download_drivers_bios.jsp Thanks for the help. Onto the next issue.
I Have the same problem as Marlene. Report RussTiger- Sep 12, 2009 01:02AM Thanks man disabling the Sata native did the trick thanks a LOT!!!!!!!!!!!!!!!!!!!!!!!!!!!! Then connect up your original drive as secondary so that both of them are in the pc at the same time. but rather use this one: http://forum.driverpacks.net/viewtopic.php?id=1449 What this lead me to is a site called http://www.driverpacks.net It contains alot of different driver packs, I used my xpsp2 and slip streamed the
Helpful +8 Report blendax 14Posts Friday August 8, 2008Registration date February 28, 2009 Last seen Aug 11, 2008 09:42AM hello, so the problem is that you must have a start up The buy gives HPE an installed base, ... I have also a T61 and I solved the problem with Solution 1! Simly stupid mind!
I use a HP pavilion DV1000laptop. If you borrow a floppy drive and a floppy data cable from another computer, you can install the SATA drive controller drivers from a prepared floppy disk after pressing F6 near I suspect that if you have been happily using your PC that you are not trying to run Windows XP Setup - please confirm.
© Copyright 2017 wphomeguide.com. All rights reserved.